BBQ & Smoke Recipes
Char-Broil
Recipes in this file:
Last modified 9/27/13
  1. Uncle Steve's HOT Lava BBQ Glaze
  2. Dan's Smokehouse Jerky - The Best
  3. Hatch Green Chili BBQ Shrimp



{ Exported from MasterCook Mac }

Uncle Steve's HOT Lava BBQ Glaze

Recipe By: Steve Nearman http://usHOTstuff.com
Serving Size: 1
Preparation Time: 0:00
Categories: Hot & Spicy Uncle Steve's

Amount Measure Ingredient Preparation Method
1/2 cup Ketchup
2 teaspoons Uncle Steve's #1 Hot Spice Mix
2 teaspoon Worcestershire Sauce
1 teaspoon Salt
1 cup Vinegar
4 tablespoons Dark Molasses
1/4 cup Brown Sugar

Mix all ingredients in a small sauce pan over medium heat until well mixed and sugar dissolved. Do not boil. Taste and adjust to your liking. The time to apply this sauce is when the meat has finish cooking. While sauce is still hot coat meat with paste and finish cooking at 325F for about 10-15 minutes. Just enough for the glaze to caramelize. Don't over cook.

This sauce is powerful hot so its best to only coat the top of the meat.

Notes: Use this sauce as a finishing glaze for dark meats and ribs when slow BBQ smoking.



Page Index
{ Exported from MasterCook Mac }

Dan's Smokehouse Jerky - The Best

Recipe By: Dan Sawyer; dan813@aone.com
Serving Size: 1
Preparation Time: 0:00
Categories: Jerky Wild Game

Amount Measure Ingredient Preparation Method
-- Meat --
venison
top round steak
turkey breast
-- Brine --
kiln dried medium salt
molasses (Brer Rabbit light or Grandma's)
black and/or red pepper

The Meat: Generally, the lean scraps from most venison (elk, deer, caribou, antelope and moose) work very good. Bear is greasy(sorry Bear), as is pork. Buffalo is similar to beef and makes good jerky. The best cut of beef that will yield the most usable lean meat is the top round. If you like turkey, use large bone in breasts and remove the bone. I haven't done reptiles, but what the hey, if that's your bag give it a shot. The meat should be reasonably aged, at least kept cool for a week or so after it's dressed out and skinned. It is important to trim as much fat off as possible, even if you have to cut it out or scrape it off. The fat will not take salt very well when the meat brines, it will become rancid and grow mold quickly. Cut the meat with the grain, into strips as big around as your thumb (3/4-1" square) and as long as possible.

The Brine: This is a self brining method and works in two stages, dehydration and rehydration. The ingredients needed are: A kiln dried medium salt. Most feed stores have 50# bags for about $3. which will make about eight thousand pounds of jerky. Medium salt is about the size of salt that comes on a pretzel. Molasses. I use Brer Rabbit light or Grandma's. Brer Rabbit comes in pint bottles and have a small top that you can pour a nice 'string' from. Grandma's comes in a large mouth bottle and it's best if you transfer it to some sort of a squeeze top ketchup or pancake syrup bottle (1 pint = about 20# of meat). Black Pepper, medium grind or coarse - your choice. If you like it hot, use red pepper flakes instead, if you don't like pepper leave it out. This brine process goes easier and more quickly if you have a few extra happy hands joining in - the kids, the wife and myself usually make it a project and when it's done everyone gets to pat each other on the back. Since we're all together and helping each other, some interesting conversations usually surface. Anyway, you will need a flat bottom non-corrosive container and lid, a Tupperware storage bin, a plastic bus tray or a stainless steam table pan will work well. The size depends on the amount of meat and the room in your refer - the lids keep things out and are handy for stacking the containers. Salt the bottom of the pan evenly, making sure to get in the corners as well. This may not be as easy as it sounds. Put a few pounds of salt in a bowl, cup your fingers together and scoop out about a half a handful - not in your palm. Shake your hand back and forth across the top and about a foot above the top of the pan. As the salt starts to leave your hand, slowly open your fingers and let the salt run through evenly. Hand salting may require some practice. Practice salting the bottom of the pan until it becomes comfortable and the coverage is without gobs or streaks or voids. If this method becomes too frustrating, a shaker top jar works too - a mayonnaise jar with the metal lid poked full of holes by a 16 penny nail. The coverage amount should be between light coverage (barely covering) and full coverage (completely covering) - the only comparison I can think of, is sugar on a pie crust, or, sugar on your cereal. You don't want it too salty, so, one might consider their first batch of jerky experimental and take it from there. String the molasses. Same kinda deal as the salt, hold the bottle about a foot above the pan, start moving it from side to side and pour. When the molasses starts running try to get a 'string' about the size of a pencil lead and let it crisscross the pan bottom over the salt. Once the strings are even in one direction, change directions (perpendicular) and string evenly across again. Don't forget the corners. When it's done it will be an even grid about 1/2" square covering the pan bottom. Good luck... don't worry, 10-12 layers and you'll be able to sign your name with it. The pepper will vary as to individual taste. One note though, pepper almost doubles its intensity as it soaks and is easy to overpower the finished product. I would recommend that a light dusting would be sufficient for most people (about the way you would pepper a baked potato). Red pepper flakes, even more so. Again, hold the pepper can about a foot above, and dust it evenly - good, you remembered the corners. Layer the meat strips across the bottom of the pan one at a time. Starting on one side, place the strips next to each other without overlapping and with all of the strips running in the same direction. Work the meat across until the layer is complete, without voids. Pat the surface, edges and corners down smooth and flat. Salt, molasses and pepper the surface as was done to the bottom of the pan to start. The second layer of meat is done the same, but it is ran perpendicular to the first layer. Pat smooth, salt, molasses and pepper. Each additional layer is placed perpendicular to the layer before it. Continue layering the meat until it reaches to a level about 2" from the top of the pan. The last layer, or partial layer, gets the salt, molasses and pepper treatment as well. This brining method will cure the meat in two days. Place the pan in the refer, cover and let sit undisturbed for the first day (refrigeration is not necessary if prepared in a cool climate 35-45F). After about 24 hours the meat should be 'turned' - Dig your hands in the pan and separate all of the strips, turning it over several times to get the meat redistributed into a random order. Mash the meat back down into the brining juices ( at this point the juice will be thin and watery) cover and let sit for another day. I usually taste the juice at this point - if it tastes too salty it can be rinsed with water, but it will not be as good. If the salt is right it will have a slightly sweet, peppery flavor. During this next day the meat will soak up the brine juices and when the meat is removed before smoking, it will have a 'candied' texture - sticky and pliable. There should be very little, if any, brine solution left in the pan. The meat will have soaked up the brine and be somewhat swelled up, as compared to the first turning.

Smokehousing the meat: The smoking process will require a smokehouse or smoking unit that is capable of maintaining 80-90F. If there is a small volume, piping the smoke from an external source will provide a cooler smoke, and a hot plate or a few briquettes/lump charcoal could provide the heat source. In a medium size unit (refrigerator size), a cast iron frying pan with chips set on a hot plate will work - although it may be difficult to maintain a constant temperature. The more volume, the easier it is to control the temperature. I would recommend that a fire be built and maintained throughout the smoking process, which will take from 48 to 70 hours - depending upon the thickness of the meat. The smokehouse that I use is medium - large (350) cu.ft., it will maintain a good smoky 80-100F with 2-3 half gallon milk jug sized pieces of wood burning. Use seasoned, barkless wood - your choice, I use red alder, apple, plum, cherry, oak, pear and some of the best I've ever done was with some 75 year old grape stumps. Citrus works good too. Get the smokehouse going and rack or hang the meat while the temp becomes stabilized. If you rack the meat, place it *without* the pieces touching each other - just enough room to run a finger between the strips. Stainless 3/16" rod sharpened on both ends works good for hanging - again, leave some space between the strips. As you place the strips, run them through your thumb and index finger to squeegee off any excess brine. Before placing the racks or skewers into the smokehouse, coarse black pepper or additional red pepper flakes may be added - for those who like lotsa zip. Load the smokehouse and leave the door cracked open for the first couple hours, or until the surface of the meat has dried to the touch. Close the doors, poke the fire and keep an eye on the temps for a couple of days. Don't worry about the meat spoiling if the fire goes out. The meat is cured. It's said that the old timers used to make their jerky while they traveled. When they made camp at night they would hang the jerky over the campfire until dawn, when they broke camp they simply packed up the jerky and continued smoking the next night. This process takes about 4-5 days and is worth every minute. Probably the two most important items would be too much salt and too much heat. If you decide to try this method, I garr-own-tee you'll never find another piece of store bought jerky that even comes close.

Notes: I would like to share a jerky making process that goes back a long way, before refrigerators, before electricity. To the best of my knowledge it has never been written down, just passed along from one old timer to the next - until now... Showing a person how to do something is one thing, but putting it into words is,... an incommodiously arduous task?



Page Index
{ Exported from MasterCook Mac }

Hatch Green Chili BBQ Shrimp

Recipe By: Matt Montano mattrmon@yahoo.com
Serving Size: 1
Preparation Time: 0:00
Categories: Grilled/Smoked

Amount Measure Ingredient Preparation Method
2 Dozen Large Peeled & Devined Shrimp (Prawns)
5 Fresh Roasted Hatch Green Chilis w/seeds
3 cups Dry white wine (Chardonay works good)
Juice from 3 oranges
2 TableSpoons chopped garlic

Place all in a large ziplock type bag and marinate for about 2 hours.

Drain liquid saving chilli from bag and place Shrimp on the grill and coat w/the chili, Grill until opaque or desired and enjoy.

The more chili the better the taste!!!

Enjoy!

Page Index

More to come. Check back soon!
Add Your Recipes!


[ Steve's Recipes ] ~ [ Lindy's Recipes ] ~ [ Favorite Recipes ] ~ [ Recipes Index ]
[ Add Your Recipes ] ~ [ Hot Sauces Recipes ] ~ [ Wild Game Recipes ]




[ Home ] ~ [ Heat Scale ] ~ [ Recipes ] ~ [ Growing Tips ] ~ [ Eating Contests ]
[ Hot Links ] ~ [ Seed Sources ] ~ [ Books ] ~ [ Order Products ] ~ [ Chile Game ]